PDF guides

Position crop marks outside a PDF's bleed area

·

Give a printer cut guides without drawing over the bleed. Crop marks align to the sides of the finished page and start beyond the surrounding bleed. Check the spacing before choosing a paper size for the marked PDF.

Add PDF Crop Marks

Position eight marks on the Harbor Postcard

Open the Harbor Postcard sample or choose Load postcard example. Enter 1 in Pages to edit. Keep Points, set Mark length to 12, Offset from bleed edge to 6 and Stroke width to 1. Choose Add crop marks.

Page 1 has a 216 × 144 pt TrimBox and a 234 × 162 pt BleedBox. Its 9 pt bleed plus your 6 pt offset puts each near endpoint 15 pt from the trim edge. The visible page reads 272 × 200 pt, which includes one point of outer space beyond the marks.

Choose Compare original and result. In the result, check for two lines at each corner, aligned with the sides of the finished card. The unused second page stays as it was.

Harbor Postcard press sample PDFAdobe InDesign guide to printer marks

Check that the marked sheet fits the paper

Change the offset to 3 pt and apply to the same original page. The nearest mark ends move from 15 pt to 12 pt beyond trim. The visible size drops to 266 × 194 pt because both opposite margins are 3 pt smaller.

Download pdf-press-postcard-with-crop-marks.pdf and reopen it with the complete page visible. A reader set to show only trim can hide the marks. If the paper has too little room, check the printer's allowed mark offset, length and bleed before changing them. For a physical proof, use actual size and measure between opposite cut guides.

Harbor Postcard press sample PDFAdobe InDesign guide to printer marksAdobe Acrobat guide to PDF page boxes

Common questions

Why do some crop marks look farther from the trim than others?

An existing BleedBox can sit farther outside one edge of the TrimBox than another. The offset is measured from the corresponding outer bleed edge.

Are these also registration marks?

They are black corner lines for cutting. Ask your printer which registration, color and imposition marks are needed for the job.

Sources

Put it into practice.

Related guides