Compare sample rates in an M4A-to-MP3 export
Admin ·
MP3 bitrate and sample rate control different properties. If the receiving player expects a particular rate, choose it before comparing file sizes.
Keep 64 kbps and change the sample rate
Load M4A practice audio and choose 22,050 Hz with 64 kbps. Compress to MP3 and save the file. Open a media inspector and check for two channels and approximately six seconds.
Change the sample rate to 16,000 Hz and leave the bitrate at 64 kbps. Export again. Both files should be close to 48 KB of audio data. Frame alignment and headers can change the measured size slightly.
Listen to both results. The allowed bandwidth changes even though the stored bits per second and the nominal audio data size stay the same.
FFmpeg LAME MP3 encoder optionsThree-tone stereo WAV practice source
Check bitrate availability at low rates
Try 8,000 Hz after choosing 192 kbps at 44,100 Hz. The workspace switches to an available bitrate and reports it because that pair is outside the supported MP3 range.
When you choose to keep the original rate, read its displayed value. A source above the supported MP3 rates uses the closest compatible rate at or below it.
Identify the audio inside the M4A
An M4A may store AAC or Apple Lossless audio. This workspace can read either unprotected stream and write MP3.
Keep the original if you need the source audio for editing later. A lower MP3 bitrate can discard detail.
FFmpeg AAC and MOV/MP4 demuxer documentationFFmpeg LAME MP3 encoder options
Common questions
What do I check when compressing a voice memo?
Confirm that the destination accepts MP3 and compare the measured bytes and audible quality on a section with clear speech.
Can I use a bitrate above 64 kbps at 8 kHz?
The 8 kHz selection in this workspace offers up to 64 kbps. Choose a higher sample rate to see more bitrate options.