Fit an A4 proof onto US Letter without cropping
Admin ·
A designer sends an A4 proof to a colleague with Letter paper. The source is narrower but taller than the target. Scaling by width alone clips the bottom. Use both dimensions to calculate a fit, then tell the recipient which print settings produced the result.
Find the limiting edge on US Letter
Use the defaults: A4 portrait, US Letter portrait and zero minimum margin. The width ratio is 215.9 ÷ 210, about 1.028. The height ratio is 279.4 ÷ 297, about 0.941. The smaller ratio sets the scale: 94.074%.
The fitted proof is 197.556 mm wide and 279.4 mm tall. Centering leaves about 9.172 mm at each side. If you must enter the percentage as a whole number, select 94% and inspect the print preview.
Leave a real margin on all four edges
Set Minimum target margin to 10 mm. Subtract 20 mm from both target dimensions before dividing by source dimensions. The available rectangle is 195.9 × 259.4 mm, and height still limits the scale. The result is 87.34%, with 10 mm at top and bottom.
Rotate only the target to see why landscape paper can make a portrait proof smaller. If both source and target turn by 90 degrees, their limiting ratio stays the same. Compare the edge spacing in the results table.
Keep the physical proof separate from its raster resolution
At 300 PPI, A4 rounds to 2,480 × 3,508 pixels. Change the resolution to 150 PPI. The source raster changes to 1,240 × 1,754 pixels while the physical sheet and fit percentage stay the same. PDF points use 72 points per inch independently of PPI.
Download measurements before sending instructions. A printer that applies its own fit a second time can shrink the artwork again. Check its preview or a measured proof before printing a batch.
Common questions
Why are the two side margins larger than the minimum margin?
When height is the limiting dimension, the fitted width can leave extra space. The calculator divides that remaining width equally between the left and right edges.
Can I fit a custom label without enlarging it?
Choose Custom for the source, enter its physical dimensions and clear Allow enlargement. A source that already fits keeps its size. A source that exceeds the available area still shrinks.