Add a running report title and a numbered footer
Admin ·
Before adding running text, inspect the top and bottom margins of the document. Existing material can occupy those margins even when a page looks mostly blank.
Set the report title
Enter Field notes in Header and Sheet {page} of {total} in Footer. Set the inset to 18 points and choose left alignment. Apply to pages 1-2 and inspect the comparison. Both blocks start a quarter inch in from the visible left edge.
Start a separate section count
To start a new section on source page four, select that page and the following section pages. Use Section page {n} in Footer and set the starting value to 1. The running header can stay unchanged across the selected section.
Avoid a collision with an existing running header
Use one page with a large chapter title and another with a dense table as your trial range. A footer clear on the title page may overlap a source page number later. Compare both before applying the settings to the full packet.
If the new footer intentionally repeats the document title, shorten the header or move it to a quieter edge. Open the saved pages at their intended print size to judge clearance around descenders.
Common questions
Can I give the footer a separate alignment?
This tool uses one alignment for the two marks. Apply the header alone, then open the saved copy and add the footer alone for different alignments.
Will an existing header be replaced?
The tool draws new content. Choose clear page areas to keep the existing material readable.