Position a translucent watermark on mixed PDF pages
Admin ·
A draft label is easiest to read when it is large enough to recognize and light enough for the source text to remain legible. Check at least one densely printed page.
Place a diagonal draft label
Enter DRAFT, choose center, set the angle to 30 degrees and opacity to 30%. Test a middle page before expanding the range. Positive angles turn counterclockwise in the displayed page space. If the rotated label exceeds a smaller page, reduce its size or inset.
Adobe PDF Reference, sixth editionPDF-LIB page drawing and page boxes
Size an image mark in points
Choose Image logo and a transparent PNG twice as wide as it is tall. A width of 72 points gives a height of 36 points. Set the angle to zero and choose bottom right for a horizontal one-inch-wide mark.
Inspect marks over text and diagrams separately
Test a watermark on a page of small text and a page with a pale diagram. Adjust opacity until both remain readable on screen. A logo with a white rectangle behind it can obscure more than its lettering suggests.
Print one of the marked pages in grayscale if the document will be photocopied. A draft label communicates status but can be copied or removed by a PDF editor. Use the original document as the record of the approved version.
Common questions
Does choosing opacity 50% replace the logo’s transparency?
The page drawing opacity combines with the transparency already present in the logo.
Are earlier watermarks removed?
The edit adds one visible watermark to each selected page. Any existing marks remain in the original page content.
Sources
Put it into practice.
Related guides
- Place a review label on selected PDF pages
- Start numbering a PDF after its cover
- Set a running PDF heading and footer
- Measure a PDF border from the page edge
- Stamp Two Selected PDF Pages as Approved
- Add and verify multiple PDF review notes
- Place an Image on Two Rotated PDF Pages
- Watermark Even Pages Across a PDF Batch