Stamp two selected PDF pages as approved
Admin ·
An inventory PDF has four pages. Only pages 2 and 4 are ready for review. Place the same visible status on both pages so the remaining pages retain their original appearance.
Set the approved stamp on two pages
Choose Load inventory PDF example. Keep the APPROVED preset at 22 points and 85% opacity with the border enabled. Keep Top right and an edge inset of 18 points.
Enter 2,4 in Pages to stamp. Switch Page to preview to 2 and then 4. Both previews place the green label against the upper-right edges you see, even though those two pages have different rotated dimensions.
Compare the stamped pages and their neighbors
Choose Prepare stamped PDF. The tool reports two marks on two pages. Choose Compare original and result, then inspect page 2. The InventoryCode field still reads X-27 and the original inventory line remains.
Download stamped.pdf. Open all four pages and check that the stamp appears only on pages 2 and 4.
Set a custom label and angle
Select Custom and type FOR REVIEW. Try Center, a −30° angle and 45% opacity. Preview every selected page so the rotated label fits and the content underneath stays readable.
A review stamp adds visible text to the output. Use certificate signing or an approval system when records need to identify the reviewer.
Common questions
What if my stamped label is too large for one page?
Reduce the text size, inset or angle. The PDF is prepared only when the stamp fits every selected page.
Can I put the stamp at an exact point?
Select Custom offsets and enter left and top values in points. The offsets apply to the outside bounds of the stamp, including its rotation.