Audio and video guides

Compare Two Mono MP3 Exports for a Podcast

·

Make two copies from the same master when choosing a podcast bitrate. Compare the measured file sizes, then listen to the same phrase in both outputs before replacing your distribution file.

Podcast Audio Compressor

Export the same six seconds at 64 and 96 kbps

Open the six-second WAV or choose Load practice audio. Its source shows 384,044 bytes, 16,000 Hz and stereo. Select 96 kbps, leave the 80 Hz high-pass filter on, and choose Compress podcast episode. Verify the output panel shows a 44,100 Hz mono MP3.

Save the first file before changing the bitrate, then repeat at 64 kbps using the same source. Both preserve the full recording. The estimated audio payload is 72,000 bytes at 96 kbps and 48,000 bytes at 64 kbps. Compare those estimates with the saved files. MP3 frames and headers add bytes.

Open Podcast Audio CompressorDownload the six-second stereo WAVFFmpeg libmp3lame encoder options

Check that both channels reach the mono mix

The sample has different tones in its left and right channels. Compare around 0.5, 3 and 5.5 seconds. Both original channel tones should be audible together in each mono export.

For a real interview, listen to phrases where a speaker is isolated in one channel. Also listen to parts with the same signal in both channels. Opposite polarity can weaken shared sound when channels are averaged. Keep a stereo master for editing and for material that relies on stereo separation.

Open Podcast Audio CompressorDownload the six-second stereo WAV

Check the host's settings before publishing

Check what your podcast host accepts before choosing a delivery file. Apple Podcasts Connect lists 96 to 128 kbps at 44.1 or 48 kHz as recommended settings for mono subscriber MP3. A different host or feed can have different requirements.

Compare the 80 Hz high-pass switch with the same bitrate on your own master if you hear low rumble. Leave it off when low-frequency music or ambience is important and the filtered copy changes more than you want.

Apple Podcasts Connect audio requirementsFFmpeg highpass filter

Common questions

Can the sample tell me which bitrate will suit a real episode?

It demonstrates file size and mono mixing. Use your own speech, music and quiet sections to check audible detail at both bitrates.

Why do both bitrates show the same channel count?

Podcast output is mono at every bitrate. Changing bitrate changes data per second while the channel mix stays the same.

Sources

Put it into practice.

Related guides