Audio and video guides

Check Loudness and File Size in a Voice Memo MP3

·

A smaller voice memo needs to remain understandable at its final playback volume. Compare the same recording with and without speech loudness adjustment at one bitrate before changing several settings.

Voice Recording Compressor

Check the 64 kbps practice export

Choose Load practice audio or open the linked six-second WAV. Keep 64 kbps, the 100 Hz high-pass filter, and both checkboxes selected. Compress the recording. The preview should show a mono MP3 at 16,000 Hz, a speech gain value, and its measured size. The estimated audio payload is 48,000 bytes.

Listen near 0.5, 3 and 5.5 seconds and confirm all three tone groups play. Save the file, turn off Normalize speech loudness, and encode again at the same bitrate. Compare at the same playback volume. Changing gain leaves the bitrate setting fixed, so both files use similar bytes.

Open Voice Recording CompressorDownload the six-second stereo WAVFFmpeg libmp3lame encoder options

Choose a cutoff and listen to the whole memo

Use your own voice recording for the listening test. Start with Off and 80 or 100 Hz on the same phrase. Raise the cutoff to 150 or 200 Hz when stronger rumble persists and the lower voice still sounds clear.

Clear Convert to mono when your interview needs separate stereo channels. When you choose mono, verify a phrase recorded on the left and another recorded on the right are both present. Listen for room echo and fan hiss too. They can remain after high-pass filtering.

Open Voice Recording CompressorFFmpeg highpass filter

Read the loudness adjustment and check for clipping

Normalize speech loudness compresses loud peaks, then uses an integrated measurement to calculate a gain adjustment toward −18 LUFS. Before encoding, the calculation allows up to 12 dB of boost and respects a −2 dBTP ceiling. Either limit can keep a clip below the nominal target.

Listen to the quietest words and loudest sentence in the MP3. If a change exaggerates room sound or flattens the emphasis, compare the copy made with speech normalization off.

ITU-R BS.1770 methods for loudness and true peakFFmpeg acompressor filterOpen Voice Recording Compressor

Common questions

Do I have to choose a higher bitrate to use a high-pass filter?

You can set the cutoff and bitrate independently. Compare the same phrase and keep the setting that sounds clear at the size you need.

How do I compress a clip shorter than 0.4 seconds?

Turn off Normalize speech loudness. High-pass filtering and MP3 encoding are available from 0.1 seconds.

Sources

Put it into practice.

Related guides