Audio Normalizer
Normalize local audio to a LUFS or sample-peak target. Set a true-peak ceiling and maximum gain, then preview a WAV or FLAC export.
Normalize Audio to LUFS or dBFS
Audio Normalizer: how to use it
- Open an audio file and select the interval to normalize. Leave End blank to include the rest of the file.
- Choose Integrated loudness for a LUFS target with a true-peak ceiling and boost limit. Choose Sample peak to set the highest sample in dBFS.
- Choose WAV or FLAC and normalize. Review the measured source levels and applied gain before downloading.
Limits and notes
One supported WAV, MP3, AAC/M4A, Ogg, FLAC or audio-only WebM file up to 100 MB and 15 minutes. Supports 8–192 kHz input and up to eight channels, with a 64 MB decoded output budget. Integrated measurement requires 0.4 seconds or more. Both modes apply one gain and export 16-bit WAV or FLAC. A true-peak ceiling in LUFS mode can keep the output below the loudness target.
How your privacy works →Audio Normalizer: common questions
Does peak normalization match perceived loudness?
Peak normalization sets the highest sample’s level. Measurements such as integrated LUFS also take the level over time into account. Files with matching peaks can sound different in loudness.
Will stereo balance change?
Both methods apply the same gain to every channel, preserving balance. In LUFS mode the boost or true-peak setting can constrain that gain.
What happens with a silent or nearly silent selection?
Digital silence stays silent. The LUFS mode reports when the selection is below the loudness gate. Peak mode limits boost to 36 dB.
Why can the result be below my requested LUFS?
The tool caps the gain when the true-peak ceiling or boost limit would be exceeded. It uses one gain throughout the selection without reshaping peaks.