Audio and video guides

Normalize an audio excerpt to a LUFS or sample-peak target

·

Integrated loudness normalization applies one gain based on the measured level over the selected interval. Use a LUFS target for a loudness specification and a sample-peak target when you need a particular maximum sample value. Both methods preserve the relative levels of channels.

Audio Normalizer

Check a −23 LUFS export and its true peak

Open the noisy stereo WAV sample. Select 0.75 to 1.75 seconds, Integrated loudness, EBU R128 broadcast and FLAC. The source reads about −13.15 LUFS and −10.43 dBTP. The browser applies −9.85 dB and a separate loudness scan reads about −23 LUFS.

To see what the ceiling does, enter a custom −5 LUFS target and choose −6 dBTP as the ceiling. The browser applies about +4.41 dB. A separate scan reads about −8.7 LUFS and −6 dBTP. Reaching −5 LUFS would require more gain than the peak ceiling permits.

The first pass measures the source over the selection. The second applies one calculated gain. That keeps changes in level within the selection and avoids compressing peaks.

Download the noisy stereo WAV sampleEBU R 128, loudness normalisation and permitted maximum levelFFmpeg, integrated loudness and true-peak measurement

Set a −3 dBFS peak and leave headroom

For the same interval, choose Sample peak, −3 dBFS and FLAC. The measured source peak is about −10.64 dBFS for that interval. The tool adds about 7.64 dB to both channels.

Reopen the download and check for 32,000 frames per channel, two channels and one second at 32,000 Hz. The checked output peaks at about −3 dBFS, or 70.8% of full scale. The same multiplier applies to the left and right samples.

Download the noisy stereo WAV sampleFFmpeg audio statistics and peak levelIETF RFC 9639, Free Lossless Audio Codec

Leave room for EQ and later edits

Choose a lower target such as −6 dBFS when equalization, effects or mixing could lift peaks again. Recheck the final file after those steps. A meter that reconstructs between-sample peaks can read higher than a sample-peak measurement.

Matching sample peaks gives a consistent maximum sample value. For a delivery specification that asks for integrated LUFS or true peak, measure those units on the final export using the specified method.

EBU R 128, loudness normalisation and permitted maximum levelFFmpeg audio statistics and peak level

Decide when a very quiet clip needs rerecording

One gain boosts the wanted sound and its background noise together. Peak mode caps boost at 36 dB. A −50 dBFS peak and a −3 dBFS target would need 47 dB, so the strongest sample stays around −14 dBFS. In LUFS mode you can choose a lower boost cap.

Integrated measurement needs at least 0.4 seconds. Select a longer passage or use peak mode for a short cue. Audio below the integrated measurement gate cannot be boosted to the target with a meaningful loudness reading. Digital silence stays silent.

Listen for room tone after applying gain. A new recording with stronger input level or a separate noise reduction step can be more useful than another gain pass. The browser performs both peak measurement and encoding locally.

Common questions

Does the normalizer lower loud selections?

Yes. If the source peak is higher than the chosen target, a negative gain brings the peak down and applies the same change throughout the selection.

Will the download keep its original channel count?

Yes. A common gain preserves the relative levels of all channels. The output keeps the input sample rate and uses 16-bit WAV or FLAC.

Sources

Put it into practice.

Related guides