Audio and video guides

Choose a stereo-to-mono mix using the same audio

·

Mono can contain both sides of a stereo recording or just the side you want to keep. Listen to each input channel before choosing a mix for speech or music.

Stereo to Mono Compressor

Hear two distinct sides in the practice audio

Load the six-second practice audio. Keep WAV and a 44,100 Hz maximum. Save Average channels, then Left channel only and Right channel only. All three outputs should report one channel and the original 16,000 Hz rate.

Compare the opening two seconds. The left source tone is 440 Hz and the right is 660 Hz. The average contains both tones. If the right side of an interview has noise, apply the same left-only technique to keep the clean side.

Six-second stereo tone practice recordingFFmpeg pan filter for channel mappings

Compare summed audio with peak limiting

Choose Sum with peak limiting and save another WAV. This combines the channels at a higher gain than averaging and attenuates peaks that cross the limiter. Listen for changes where channels carry similar audio.

FFmpeg pan filter for channel mappingsFFmpeg peak limiter and latency options

Save a lower-rate mono MP3

Switch to MP3 and set an 8,000 Hz maximum. The result should report 64 kbps and one channel. Compare bytes with the 16,000 Hz WAV and listen for reduced upper-frequency detail before using the smaller file.

FFmpeg libmp3lame bitrate optionsSix-second stereo tone practice recording

Common questions

Which channel is left for an existing mono file?

A mono source has one channel. Every mix choice keeps that channel and the output format and sample-rate controls still apply.

Can averaging remove sound from a recording?

Similar signals of opposite polarity can cancel when combined. If part of the recording becomes quiet or disappears, compare each channel on its own.

Sources

Put it into practice.

Related guides