Stereo to Mono Compressor
Average, select, or sum audio channels into mono. Set a maximum sample rate and download a 16-bit WAV or 64 kbps MP3.
Compare Stereo-to-Mono Mix Modes
Stereo to Mono Compressor: how to use it
- Open a stereo recording or load the practice audio, which has a different tone in each channel.
- Choose average, left, right or the peak-limited sum. Set a maximum sample rate and choose WAV or MP3.
- Convert to mono. Listen to the single-channel result and check its written sample rate and measured size before downloading.
Limits and notes
Use one supported audio-only file up to 100,000,000 bytes, from 0.1 seconds to 15 minutes. Maximum sample rates are 8, 16, 22.05 and 44.1 kHz. WAV is 16-bit PCM. MP3 uses 64 kbps and needs a source rate of at least 8 kHz. For multichannel sources, left and right choose the first and second channels.
How your privacy works →Stereo to Mono Compressor: common questions
Does mono cut every audio file in half?
At the same rate and bit depth, mono PCM uses half the sample data of stereo PCM. A codec, bitrate or rate change also affects the saved size.
Which mix should I use when one side contains noise?
Choose the clean channel on its own. Average includes both sides and the sum combines them at a higher level with peak limiting.
Why is the output rate below the maximum I selected?
The maximum is a ceiling. WAV keeps an already lower source rate, and MP3 chooses a compatible rate at or below the ceiling.