Photo editing guides

Place a translucent logo with a measured inset

·

A consistent watermark uses the same relative logo width across photos, plus enough margin to avoid placing the logo against the edge.

Image Watermark Adder

Size the logo relative to the photograph

On an 800 × 600 image, a logo width of 25% requests 200 pixels. A 2:1 logo becomes 200 × 100. With bottom right selected and an inset of 20, its top-left pixel is at (580, 480). An oversized logo is reduced to fit the available inset area.

Check contrast at the intended opacity

Choose 50% opacity and compare the before and after previews. An opaque logo region blends with the photo, while a fully transparent region shows the source. Switch to a text credit if the logo becomes hard to recognize at the chosen size.

HTML Standard — canvas shapes, text and compositing

Test on the lightest and darkest photographs

Try one pale sky and one dark doorway with the same transparent logo. The percentage width keeps the mark proportional to each picture. It does not ensure the logo is readable across both backgrounds.

Inspect the exported corners at the display size used by the gallery. Choose a light or dark logo variant from the source artwork when opacity alone cannot make its edges legible.

Common questions

Can I remove this watermark later by editing a text layer?

The saved PNG contains composited pixels. Keep the source and logo if you want to change the placement later.

Will the logo stretch to fit its box?

Width and height use the same scale factor, including when the inset limits the available space.

Sources

Put it into practice.

Related guides