Audio and video guides

Compare Sample Rate and Bit Depth in Smaller PCM WAVs

·

Choose WAV settings by deciding which audio properties your destination requires. Compare sample rate and bit depth one at a time to find a smaller PCM file that still plays clearly.

WAV Compressor

Save an 8-bit stereo WAV at 8 kHz

Choose Load practice audio or open the linked WAV. It has six seconds of stereo PCM at 16,000 Hz and uses 384,044 bytes. Set PCM bit depth to 8-bit PCM and Maximum sample rate to 8,000 Hz. Choose Compress WAV.

Check the output reports 8-bit PCM WAV, 8,000 Hz, stereo and six seconds. The estimated sample payload is 96,000 bytes. The downloaded WAV includes a header, so compare the measured size rather than using the payload estimate as a hard cap. Listen to all three tone groups.

Open WAV CompressorDownload the six-second stereo WAVMicrosoft WAVEFORMATEXTENSIBLE audio structure

Compare one change in PCM resolution

Save the 8-bit output, choose 16-bit PCM at the same 8,000 Hz limit, and encode the original again. The sample payload becomes 192,000 bytes. The stereo channels and duration stay the same.

To isolate sample rate next, keep 16-bit PCM and choose Keep source rate. The separate samples on both channels still play for six seconds, but the file uses twice as many samples per second as a copy at 8,000 Hz. A cap above 16,000 Hz also preserves this source rate.

Compare one change in PCM resolution
DurationChannelsSample rateBit depthAudio payload
6 s28,000 Hz8-bit96,000 bytes
6 s28,000 Hz16-bit192,000 bytes
6 s216,000 Hz16-bit384,000 bytes

Microsoft WAVEFORMATEXTENSIBLE audio structureFFmpeg resampler documentation

Match the settings to your player or editor

Play the saved WAV in the destination app and confirm that it accepts the reported sample rate, sample precision and channel count. Lowering sample rate narrows the frequency range. Lowering sample precision can make quantization noise more audible in quiet passages.

Keep your original for later editing. If the receiving app accepts a different container, compare a FLAC copy when you need to preserve the original PCM samples while using fewer bytes.

Microsoft WAVEFORMATEXTENSIBLE audio structureFFmpeg resampler documentationXiph.Org FLAC codec documentation

Common questions

Why might the exported WAV be larger than the source?

A larger bit depth stores more data per sample. A new WAV header can also add a small amount of data when the sample payload stays the same.

Does choosing a lower sample rate shorten playback?

The export resamples for the chosen rate. It keeps the full playback duration while storing fewer samples per second.

Sources

Put it into practice.

Related guides