Audio and video guides

Fit a full audio recording under 10 MB

·

For a long submission, the meaning of 10 MB can change the usable bitrate. Compare both byte conventions with an identical source before choosing one.

Compress Audio to 10 MB

Fit the 326-second recording at the binary limit

Load the 326-second practice audio. With Binary selected, the cap is 10,485,760 bytes. A 256 kbps estimate is 10,432,000 bytes, leaving room for frame and file overhead.

Compress and verify that the checked MP3 uses 256 kbps stereo. Save it and compare the exact file size with the cap. The download should still play for about 326 seconds.

NIST definitions for bytes, megabytes and mebibytesFFmpeg LAME MP3 encoder bitrate options

Switch to a ten-million-byte upload limit

Change Size convention to Decimal. The earlier download is cleared because the receiving limit changed. Compress the same source again. The 256 kbps estimate exceeds this cap, so the fitting preset is 192 kbps.

Open both downloads separately. Check that both cover the same duration and that only the smaller encode satisfies the ten-million-byte limit.

NIST definitions for bytes, megabytes and mebibytesFFmpeg LAME MP3 encoder bitrate options

Work within the full-length result

If the live check says none of the allowed settings fits, either make a smaller source in Audio Slicer or choose a larger byte budget when the destination permits. The compressor retains the recording’s duration. Keep your original for any future export.

FFmpeg LAME MP3 encoder bitrate options

Common questions

Why does the same recording use a different bitrate after I change units?

Ten MiB permits 485,760 more bytes than ten decimal MB. The additional headroom can fit a higher MP3 bitrate.

What should I check before submitting the audio?

Verify the receiving service’s exact byte cap and supported format, then listen near the end of the downloaded file.

Sources

Put it into practice.

Related guides