Write Morse clues that decode the same way for everyone
Admin ·
A puzzle clue can change when a space disappears, even if all the dots and dashes survive. Use International Morse code to write a short clue, then decode your saved text and listen for the word gaps before sharing it.
Round-trip the clue MEET AT 9?
Choose Text to Morse and enter MEET AT 9?, or use Load sample. The output is shown below. Choose Swap input and output to decode it back to MEET AT 9?. Lowercase input gives the same dots and dashes. Decoding returns uppercase letters, and several input spaces collapse to one word gap.
-- . . - / .- - / ----. ..--..Distinguish a word break from a slash inside a clue
Encode A/T. The middle group is -..-., the signal for a literal slash. Encode A T and the middle separator is a plain slash. Decode both to check that the first says A/T and the second says A T.
When pasting Morse from a typeset document, you can use middle dots and long dashes. Check that each character still occupies its own group. The fragment .. means I. Two dots separated by a space mean EE. If the preview shows a bare question-mark marker, repair the input before generating audio.
Hear the word gap at two speeds
Encode A T, set the speed to 15 WPM, and select Play Morse code. A starts with a dot and a dash separated by one timing unit. Then you hear a seven-unit word gap before the final dash for T. A dot lasts 80 ms at this speed. The clip lasts 1.2 seconds with no extra silence at the end.
Raise the speed to 30 WPM and play again. The WAV becomes 0.6 seconds long. Changing the frequency changes the pitch, while the dot-to-dash ratio and the relative pauses stay the same. Use a slower setting when you want to hear the difference between the gap inside a letter and the gap after a word.
Common questions
How can I tell a real question mark from an unsupported character?
The six-signal group ..--.. encodes a real question mark. A bare ? marks an unsupported character. In decoded text, use the warning count to tell whether an unknown group was replaced.
Why did two Morse letters decode as one?
Check for a missing space between the letter groups. For example, . . is EE, and .. is I. Restore the spaces before decoding.