Compare Opus targets and read the saved container
Admin ·
Opus has low targets for speech and higher targets for broader audio. Choose the container separately, then check a representative recording in the receiving player.
Compare 12 and 128 kbps in Ogg
Load the six-second tone practice audio. Keep the Ogg container and select the 12 kbps target. Save the .opus result and check that it reports Opus at 48 kHz.
Keep Ogg selected and set 128 kbps. Save the second .opus result. The higher target uses more bytes on the practice file. Check that both retain the six seconds and compare how each represents the tones.
For quiet speech, load a representative voice recording before choosing a low target. Smaller files can trade away stereo separation or frequency detail.
Six-second stereo tone sample used in the practice audioRFC 6716 Opus codec and bitrate rangeRFC 7845 Ogg encapsulation for Opus audio
Select WebM for a WebM delivery workflow
Change the container to WebM while keeping the target. The download uses a .webm filename and still contains Opus audio. Verify that the player or editor opens this container and check the actual size.
RFC 6716 Opus codec and bitrate rangeFFmpeg audio codec and rate-control options
Use measured bytes when the limit is strict
The target applies to the Opus audio. The measured file average includes audio, padding and container bytes. Compare actual bytes whenever the receiver has a strict limit.
RFC 6716 Opus codec and bitrate rangeFFmpeg audio codec and rate-control options
Common questions
Does a .opus result contain raw codec packets?
The .opus download contains Opus audio wrapped in Ogg. Choose WebM if the destination expects that container.
Will my stereo layout sound the same at 12 kbps?
The output can have two channels while the low-rate encoder reduces stereo detail. Compare a section where the left and right sound differ.