Audio and video guides

Speed up a color cue without raising the pitch

·

Retiming a clip changes when each frame appears. When you keep its soundtrack, check both the timing of the cuts and the pitch of a sound you can identify.

Video Speed Changer

Compare two pitch settings at 1.75×

Open the three-color sample and set Start to 2, End to 4 and Playback speed to 1.75×. The selected green section lasts two seconds, so each export should be about 1.14 seconds. The original green section has tones near 700 Hz on the left and 900 Hz on the right.

Make one download with Preserve pitch, then another with Change pitch with speed. Rename the first file before saving the second. In an audio spectrum view taken away from the boundaries, the first should stay near 700 and 900 Hz. The second should rise to about 1,225 and 1,575 Hz. Both files should still show green at the middle of the clip.

For a third comparison, select Remove audio track and export again. An independent media stream inspector should show only video in this file.

Download the three-color MP4 sampleFFmpeg, atempo and chained tempo factorsFFmpeg asetrate filter

Predict when the color changes should occur

Open the six-second color sample. Its picture changes from red to green at source time 2 and from green to blue at time 4. Set Start to 0.5 and End to 5.5.

Choose 4×. The estimated duration is 1.25 seconds because the five-second selection is divided by four. The first change should be near 0.375 seconds and the next near 0.875 seconds in the exported clip.

Download the three-color MP4 sampleFFmpeg, setpts and asetpts timestamp filters

Review the picture and pitch in the exported MP4

Leave Remove audio track unchecked. Preview the selected clip, then change its speed and download the MP4. Open it in a player or editor with frame stepping. The picture should still pass through all three colors in order at 192 × 108 pixels.

Check the green segment around 0.6 seconds. Its left and right tones should remain near 700 and 900 Hz. The audio tempo changes while the pitch stays near its source value. Frame timestamps and AAC packets cause small differences in measured duration.

Download the three-color MP4 sampleFFmpeg, atempo and chained tempo factorsFFmpeg, setpts and asetpts timestamp filters

Shorten the source selection before a slow-motion export

For a separate test, select 2 to 4 seconds and choose 0.25×. Expect about eight seconds of green. Use the source preview to confirm that the end boundary stops just before blue.

A different source may have few frames between your boundaries. Slowing it makes those frames stay on screen longer. Choose a high-frame-rate source for smoother motion.

Download the three-color MP4 sampleFFmpeg, setpts and asetpts timestamp filters

Common questions

Does 4× mean four times the duration?

4× plays through the source four times as quickly. The exported duration is roughly a quarter of the selected interval.

How do I remove sound while changing speed?

Select Remove audio track before creating the MP4. The downloaded clip will contain picture only.

Can I choose a speed between the usual presets?

Use the slider or the speed list. Both cover 0.25× through 4× in 0.05× steps.

Sources

Put it into practice.

Related guides