Compare a bass boost and treble cut on the same recording
Admin ·
Use the measured spectra to check whether an equalizer has changed the intended part of a recording. Compare the same channel and interval before and after, then listen before saving the full equalized clip.
Compare three tones with a bass lift and treble cut
Load the example and select the left channel. Set the range to 1.1–1.9 seconds and update the view. The signal contains tones at 120 Hz, 1 kHz and 6.5 kHz. The strongest measurement displays near 120 Hz, with a small rounding difference because of the frequency bin width.
Set Low shelf to +6 dB and High shelf to −6 dB. Keep Mid bell at 0 dB, then choose Preview changes. The dashed line rises near 120 Hz, stays close to the original near 1 kHz and declines near 6.5 kHz. Switch Listen to between Original and Equalized to compare the full clip.
Four-second stereo analysis sampleW3C Web Audio biquad filter definitions
Follow the left and right spectrum during playback
Set Listen to Original and start playback from the beginning with Play with live spectrum. The first second of the sample has a tone near 120 Hz on the left and another near 6.5 kHz on the right. Switch Channel and replay that second to see the dominant frequency shift.
Use Bars to see individual frequency groups or Line or Filled to see the contour. The live display follows playback. The comparison plot uses the selected analysis interval.
Four-second stereo analysis sampleW3C Web Audio analyzer frequency data
Save the full WAV and check its headroom
With these settings, the clean sample has no clipping message. Download the equalized WAV and check for four seconds, two channels, 48 kHz and 16-bit PCM. The analysis range and channel were used for the graph. They leave the full timeline and both channels in the export.
With a louder source, boosted frequencies can push PCM samples above full scale. If the tool reports clipping, lower the gain and render again. This avoids flattening peaks when writing the 16-bit file.
Four-second stereo analysis sampleMicrosoft waveform audio format fields
Read the shelf transitions and bell center
The 200 Hz low shelf changes a broad region below its transition, and the 4 kHz high shelf changes a broad region above its transition. The 1 kHz bell centers the adjustment near 1 kHz. The gain near a shelf’s transition can be smaller than the gain at its outer end.
The graph estimates levels from short windows within the selected range. A short vocal peak can fall between them. Use waveform inspection or listening to judge the timing of individual events.
Common questions
Why is the strongest frequency rounded away from exactly 120 Hz?
The graph reports the nearest measured frequency bin. At the 48 kHz analysis rate its bins are about 11.7 Hz apart.
Do the three band gains alter a stereo file’s balance?
The same filter chain runs on each channel. The perceived balance can change when channels contain different amounts of the affected frequencies.